Card Cage Removal/Replacement - Multitech MA6 Quick Start Manual

3 If LAN is connected to the MiniArray
4 Disconnect the telephone cords (RJ11) from the ISI board(s).
Table 4.1 Cable Disconnection and Rack Enclosure Removal Procedure (cont'd.)
5 Remove the four rack enclosure mounting screws from the front of MiniArray
remove the MiniArray
6 To re-attach cables and re-mount the MiniArray

Card Cage Removal/Replacement

The following table describes the process for removing the card cage. Note that card cage
removal is not always necessary to remove or replace some components. If change will
only be made to the SBC side of the card cage, the card cage does not need to be removed.
Step Procedure
1 Remove the MiniArray
2 Remove the top cover from the MiniArray
screws located in the back of the MiniArray
chassis.
MA6
Note
You may have ISI boards located in the left and
right halves of the card cage
It is recommended that two people remove the MiniArray
from its rack enclosure
III
from the rack enclosure. See Figure 4-2.
Fig. 4-2. Rack Enclosure Mounting Screws
Table 4.2 Card Cage Removal Procedure
III from rack enclosure following the procedures in Table 4.1.
III
, disconnect the 10BaseT cable at the NIC.
Caution
III
, follow steps 1-5 in reverse.
III
by removing the seven cover mounting
III
. The cover slides off the back of the
III
III and
25