Introduction; Disconnecting Cables & Removing From Enclosure - Multitech MA6 Quick Start Manual

Introduction

This chapter provides procedures for removing and replacing the key hardware components
of the MiniArray
procedures in Table 4.1 which describes the process for disconnecting cables from the back
of the MiniArray
has been designed to make this process as efficient as possible, but if you experience
problems, contact Multi-Tech Technical Support, refer to chapter 6 of this section.
Disconnecting Cables and Removal from Enclosure
The following table describes the procedures for removing the MiniArray
enclosure. These steps must be followed before any internal component can be removed or
replaced.
In order to make re-connection easier, be sure to note or label all cable connections
Table 4.1 Cable Disconnection and Rack Enclosure Removal Procedure
Step Procedure
1 Remove the power cord from the back of the MiniArray
2 If connected, disconnect the video, COM 2, and keyboard cables from the back of
the SBC.
24
III . Before removing or replacing any component, be sure to perform the
III
, and removing the MiniArray
Anytime power has to be removed, turn off the Master Power
switch inside the front door.
before disconnecting any cables from the MiniArray
Fig.4-1. Back Panel Connectors
III
from the rack enclosure. Your MiniArray
Warning
Note
III
.
•
[( )]
III
III
from its rack
III
.
MA6