Card Cage Removal/Replacement - Multitech CommPlete 4000 Series User Manual

6 To re-attach cables and re-mount the CommPlete 4000, follow steps 1-5 in reverse order
and sense. That is,

Card Cage Removal/Replacement

The steps below describe how to remove the card cage. Note that card cage removal is not
always necessary to remove or replace some components. Specifically, expansion cards can
be installed into or removed from the SBC side of the card cage without removing the card
cage. However, installing/removing an expansion card from the opposite side requires removal
of the card cage (see Figure 2-3c).
1 Remove the CommPlete 4000 from rack enclosure (two people are needed). Follow the
procedure “Disconnecting Cables and Removal from Enclosure” presented above.
Summary: after powering down the unit and disconnecting all power and signal cables,
employ two people to remove its rack-mounting screws and lift the unit out of the rack.
2 To remove the top cover from the CommPlete 4000 , remove the seven cover mounting
screws located in the back of the CommPlete 4000. The cover slides off the back of the
chassis.
3 Remove the chassis mounting screws from the card cage. See Figure 4-4.
CommPlete 4000 Communications Server Overview
All manuals and user guides at all-guides.com
a. (Two people are needed.) Attach the CommPlete 4000 to its rack enclosure using
the four mounting screws.
b. Reconnect phone cords.
c. Reconnect the Network Interface Card to the LAN with its twisted-pair cable.
d. Reconnect the SBC cables (to video, keyboard, and COM1).
e. Restore power when ready.
Cover Mounting
Screws (7)
Cover
Fig. 4-3. Cover Mounting Screws
25