Table of Contents
Advertisement
Owner´s Manual Permolock C
Installation of manual release lever in a vehicle
Read through the instructions before starting installation.
The manual release lever must be
installed so that the user can easily
operate it when necessary. The lever
is intended for cases where the vehicle
electrical system is not functioning
optimally.
Remove the plastic cover from the
lever by manually unclipping the sides
of the cover at the bottom edge,see
photo.
Preliminary adjustment
The release mechanism can be turned
to suit installation on either the right or
left side.
m
WARNING
The handle must always be mounted so that the
stop screw (7) is in front of the release handle
(1), see page 29. This will prevent the release
control from inadvertently releasing.
1. Move the stop screws between posi-
tions 2 and 7, see photo.
2. Remove the cable bracket (5) from
the release arm (10) see photo.
3. Turn the release arm (10) and move
it between fixing points 4 and 9.
4. Remove the cable bracket (5) from
the release arm (10) see photo.
Installation
1. Install the release controls using
three M4 screws with countersunk
heads through holes 3, 6 and 8, see
photo.
2. Refit the plastic cover.
The plastic cover can be unclipped
1
2
3
4
5
6
Manual release handle.
28
Installation
by hand.
7
8
9
10
Advertisement
Table of Contents
