Permobil Permolock C Owner's Manual page 23

Owner´s Manual Permolock C
6. Chassis with Pilot+
Connect the control electronics to the +24V outlet on the SLS card. If the wheel-
chair seat is equipped with an electric actuator, remove the contact for this
from the SLS card and instead connect it to the +24V outlet on the
cabling for the control electronics, see photo. For more information on the SLS
card, see the current chassis service manual.
Locking device
control electronics
Pilot+ Connect the control electronics to the +24V outlet on the SLS card. If the wheel-
chair seat is equipped with an electric actuator, connect this to the new +24V
outlet.
VSI: Connect the control electronics cables to the cables below.
Chassis with VSI
Using the cabling supplied, connect the control electronics direct to the wheel-
chair batteries.
Connect to
cabling
above.
Red
Black
Cabling for connection to VSI in chassis.
+24V outlet.
To seat actuator.
Fuse
10A.
23
Installation
Pilot+
Connect to
+24V outlet.
SLS card.
VSI
Connect to
the cabling
below.
+24V battery.
GND. Battery.