Table of Contents
Advertisement
Owner´s Manual Permolock C
Installation of locking plate
with standard bracket
Read through the instructions before
starting installation.
1. Install the four brackets in the
standard position (the central hole
configuration) on the lock plate,
see photo.
2. Position the lock plate correctly in
the vehicle.
m
WARNING
The locking plate must always be installed with
its front edge facing the direction of travel, see
photo on page 27.
3. Using the hole between the bracket
bolts as a guide, drill 4 x Ø10 mm
holes through the vehicle floor, see
photo.
4. Remove the locking plate and dis-
mount the four brackets.
5. Install the four brackets in the
vehicle
using
screws of min. M10 8.8 through the
holes previously drilled.
The screws must go right through
and have a suitable body washer
and nut on the underside.
m
WARNING
These screws are not supplied with Permolock
C. Screws must be M10 8.8 grade and of a suit-
able length for the floor thickness of the vehicle.
Incorrect fastener use could cause the Permolock
to break free in a collision and cause serious per-
sonal injury or property damage.
countersunk
26
One of the lock plates four brackets
installed in the standard position.
Use the hole between the
bolts of the brackets as a guide.
Install the four brackets in the vehicle.
Installation
Advertisement
Table of Contents
