Table of Contents
Advertisement
Owner´s Manual Permolock C
Adjustment of locking plate
Rubber rollers
The rubber rollers on the rear edge of
the locking plate can be installed in two
different positions, see photo.
Position 1: Standard, rubber rollers
mounted in the rear holes (1), see
photo.
Position 2: Alternative mounting where
the plate is fitted on a sloping surface,
and the rubber rollers are mounted in
the front holes (2), see photo.
Rubber stops
The rubber stops at the front edge of
the locking plate can be fitted with or
without spacers, depending on the spe-
cific wheelchair chassis.
Permobil C400: Fit the rubber stop
(1) with a spacer (2), screw it firmly in
place using a nut (4) and washer (3),
see photo.
Permobil C500: Fit the rubber stop
(1) without a spacer, screw it firmly in
place using a nut (4) and washer (3),
see photo.
1
The position of the rear rubber roll-
ers must be altered where the plate is
installed on a sloping surface.
The fitting of the rubber stops should be
adjusted to suit the specific wheelchair.
25
Installation
2
1
2
3
4
Advertisement
Table of Contents
