Permobil Permolock C Owner's Manual page 27

Owner´s Manual Permolock C
6. Position the locking plate correctly
on top of the mounting plates. It
can be installed in three different
positions, "Standard" or + or - 30
mm. The front hole is not used with
the standard bracket.
7. Mount the plate in the desired posi-
tion with the supplied screws and
washers.
Tightening torque:18 ft-Ibs (24,5Nm)
8. Connect the cabling from the lock-
ing plate to the vehicle's electrical
system. Connect the red cable to the
fused +12V (10A).
Red cable
Black cable
Orange cable
Direction of
travel
The lock plate must always be fitted with its front edge in the vehicle´s direction of travel.
- +12V. (10A)
- Earth
- 12V switched power, key on engine running.
FORWARD
BACK
Locking plate mounted in standard posi-
tion. The hole indicated is not used when
installing with the standard bracket.
27
Installation
Direction of
travel