Installation Of Control Electronics On The Wheelchair Chassis (C400, C500) - Permobil Permolock C Owner's Manual

Owner´s Manual Permolock C
Installation of control electronics on the wheelchair chassis
(C400, C500)
Read through the instructions before starting installation.
1. Install the control electronics for the
locking device in the wheelchair
chassis. Guide the electronics box
down on the right side of the lock-
ing device, see photo.
2. Screw down the box with the two
M4 screws supplied, see photo.
3. Using the control button bracket,
mark out attachment holes for the
bracket at the front edge of the arm-
rest. Drill Ø 3mm holes. Drill also a
Ø 6mm hole for the cable ties for
the cabling inside the armrest, see
photo.
4. Fit the locking device control button
at the front edge of the armrest using
the M3 screws supplied, see photo.
5. Fit the cabling for the control button
using cable ties inside the armrest,
see photo.
Install the control electronics box using
the M4 screws supplied.
Drill holes for the cable button
bracket and the cable ties.
Fit the control button cabling and
connection contact
with the cable ties in the armrest.
22
Installation