Installation - Posterior Mounting Block - Permobil BodiLink Head Support Operation Manual

INSTALLATION - POSTERIOR MOUNTING BLOCK

For Acta-Back, Acta-Back Deep, Acta-Back Contour, Acta-Back LTS, Acta-Embrace, Acta-Embrace LTS and Visco Back.
Note: Use of the spacer plate (E) is optional. If the spacer plate is not used, replace screws (C) with the provided shorter screws*.
*M6 X 1 X 10mm socket head cap screws
1
If the head support hardware stem is inserted in the
mounting block (B), turn the knob (A) counterclockwise to
release it. Remove the hardware stem; set aside.
2
Using the 5mm hex key, loosen the screws (C) to release
the washers (D), the spacer plate (E), and the double nuts
(F) from the mounting block (B).
3
Move the back support cover (not shown) allowing access
from both sides to the head support holes on the back
support shell (G).
4
Align the mounting block (B) and the spacer plate (E) with
the desired set of holes on the back support shell (G) and
the double nuts (F).
5
Replace the screws (C) and the washers (D) and tighten.
6
Replace and secure the back support cover.
7
Insert the hardware stem into the mounting block (B) and
turn the knob (A) clockwise to secure.
IMPORTANT! Make sure that at least ½" of the hardware
stem is completely through the bottom of mounting block (B)
at all times. See the warning in the "Important Safety
Information" section in this manual.
Note: See SUPPORT PAD installation, positioning and adjustment
instructions in this manual to make final adjustments.
For Radius Back or other compatible back supports, utilizing T-nut Head Support mounting.
1
If the head support hardware stem is inserted in the
mounting block (B), turn the knob (A) counterclockwise to
release it. Remove the hardware stem; set aside.
2
Align the mounting block (B) and the spacer plate (E) with
the T-nuts on the back support (H). Note: The Radius Back
requires creating holes in the back support cover at the T-nut
locations for attaching the mounting hardware.
3
Fasten with screws (J) and washers (D).
4
Insert the hardware stem into the mounting block (B) and
turn the knob (A) clockwise to secure.
IMPORTANT! Make sure that at least ½" of the hardware
stem is completely through the bottom of mounting block (B)
at all times. See the warning in the "Important Safety
Information" section in this manual.
Note: See SUPPORT PAD installation, positioning and adjustment
instructions in this manual to make final adjustments.
BodiLink Head Support Operation Manual
F
E
6
B
F
G
E
Rear view of Acta-Back
H
E
B
Rear view of Radius Back
support without cover
A
D
C
B
D
C
support shell
D
J