Table of Contents
Advertisement
Owner´s Manual Permolock C
Installation
Installation of locking device on the wheelchair chassis
(C400, C500)
Read through the instructions before starting installation.
1. Remove the wheelchair chassis
cover, the right-hand battery and, on
Pilot+ models, the main fuse. For a
detailed description, see the appropri-
ate chassis service manual.
2. Lift/angle the wheelchair so that the
underside of the chassis can be
accessed.
m
WARNING
The wheelchair is heavy, therefore ensure it
remains stable after the chassis has been lifted/
angled or it could fall and cause personal injury
or property damage.
3. Using a hammer and tool, tap loose
the plate covering the channel intend-
ed for the locking device, see photo.
With a long tool or similar through
the chassis channel, the plate can be
tapped loose from the inside of the
chassis and in this way there is no risk
of the plate jamming in the channel.
Use a file to remove any sharp
edges around the channel opening.
m
CAUTION
Grease the sliding surfaces of the locking
device (Mobil 1 Synthetic grease, Product
Code: 53201-0), before mounting.
Check before installation that the channel in the
chassis is free of electroplating residue and dirt
that could cause the locking device to become
stiff and difficult to operate. The lock pin could
get stuck up or down.
Tap loose the plate covering the channel.
Installation of locking device.
20
Installation
Advertisement
Table of Contents
