Permobil Permolock C Owner's Manual page 32

Owner´s Manual Permolock C
6. Screw the keyhole bolts in place
in the hole configuration that best
suits the user (choice of 4).
Use the supplied 10.5x20x2 shim
and locknut M10.
m
CAUTION
It is important that the lock plate be fitted in
a straight line in relation to the wheelchair
wheels. If necessary, fit spacers between the
keyhole bolts and the lock plate, see page 24.
The chair lock must be anchored in a manner
that is safe for the type of vehicle involved
and which conforms to the relevant country´s
regulations or the Permolock might not per-
form as certified in the crash tests.
7. Secure the screws ISO 4762
M10x35 12.9 Fe/Zn 8 C4 in the
threaded holes immediately in
front of the rear keyhole bolts, see
photo.
8. Push the lock plate into the key-
hole plates and lock by screwing
the two lock screws firmly in place,
see photo.
Screw the keyhole bolts in place using
the hole configuration that best suits the
user (choice of 4).
Hole configuration. 1
Hole configuration. 2
Hole configuration. 3
Hole configuration. 4
Fit the keyhole bolts in any of the four hole
configurations. Lock using the locking
screws after installation in the vehicle.
Permolock C installed with
quick anchoring set.
32
Installation
Locking screw