Permobil Permolock C Owner's Manual page 21

Owner´s Manual Permolock C
4. Install the locking device from under-
neath the chassis. Use the accom-
panying tool to keep the locking
device in place, see photo.
5. Install spring, washer and screw
from the upper side of the chassis.
A long screwdriver or similar can be
used to guide the parts into place.
Tighten the screw, applying pres-
sure to the underside of the chassis
using the accompanying tool.
Tightening torque: 43 ft-Ibs (59Nm).
m
CAUTION
Make sure the locking device fits easily into the
chassis channel, otherwise it will not install
properly.
6. Set the wheelchair back on all four
wheels.
7. Install the solenoid in the chassis.
Fit the solenoid in the chassis with
the flat surface of the upper part
facing backwards, see photo.
8. Chassis with Pilot+
Fit the washer supplied.
Install the main fuse along with the
plate supplied. Fit using the longer
screws supplied (M5x40) - see photo.
m
CAUTION
Note the direction in which the fuse is installed.
The ON/OFF position must match the sticker
supplied for the chassis cover.
Chassis with VSI
Fit the washer supplied.
Fit the washer using the short-
er screws supplied (M5x10), see
photo.
Fit the solenoid in the chassis with the flat
surface of the upper part facing back-
Installation of solenoid
on chassis with Pilot+.
Installation of solenoid
on chassis with VSI.
21
Installation
wards.