Adapter Plate For Corpus - Permobil BodiLink Head Support Operation Manual

ADAPTER PLATE FOR CORPUS

Attaching Bodilink Head Support Hardware to the Corpus Headrest Support Pad
Package contents: Corpus Adapter Plate; (4) M6 x 1 x 10mm socket head cap screws; (3) M6 x 1 x 20mm socket head cap
screws; (3) safety washers / Not included: 5mm hex key
Material: aluminum
WARNING: The Corpus Adapter Plate is intended ONLY to be
used with the Corpus Headrest Support Pad to attach to BodiLink
Head Support Hardware.
1 Align the holes in the Adapter Plate (A) and Corpus Headrest Pad
(B). Insert the four screws (C) and tighten.
2 Align the ball link and ball ring (D) with the ball receiver (E).
Loosely engage the three screws (F) and the safety washers (G)
with the three holes in the Adapter Plate (A).
Once all three screws are engaged, tighten them securely.
3 To position the headrest: Loosen all screws at adjustment
points, and position as desired.
Note: Loosening the three screws (F) around the ball ring will
allow pad orientation adjustment.
(H) = BodiLink Head Support Hardware
WARNING: If the three screws (F) around the ball ring are not
evenly tightened, unwanted movement may occur. After installation
and adjustment is complete, and before using the headrest, make
sure all the screws are evenly tightened.
BodiLink Head Support Operation Manual
17
A
E
A
D
B
C
G F
H