10.1 Wall mounting
Proceed as follows to mount your Pacific RO system to a wall:
1) Use a twist drill (8mm or 5/16 inch) to make the two holes in the wall that are required
as shown in the diagram above.
2) Plug the nylon S8 dowels that are supplied in the assembly kit in the holes. Screw the
5.2 x 50 mm screw hooks that are also supplied in the assembly kit in the dowels.
3) Lift the Pacific RO system (2 people are required for this) and hang the
back side of it on the scew hooks.
20
Thermo Scientific Barnstead Pacific RO
Pure water system