Printer Output; Standard Messages; Code Messages; Fault Messages - Thermo Scientific Barnstead Pacific RO 3 Operating Instructions Manual

12.3 Printer output

Various parameters can be recorded by means of a printer. A distinction is made between three
types of messages:

- Standard messages

- Code messages

- Fault messages

12.3.1 Standard messages:
A record of all measured values is printed out here in dependence on the sender interval.
Print-out:
e.g.:
TC off UV off
LF2=
LF3=
Temp.= off
12.3.2 Code messages:
Whenever a code number is entered in the system control and confirmed with the Enter-key, then
the code input is immediately printed out.
For code identification refer to the „Assignment Table for code numbers that allow the system to
be unlocked".
Print-out:
e.g.:
12.3.3 Fault messages:
Should a fault message be shown in the display, e.g. for the pure water limiting value, then this
fault message is printed out after the sending interval.
Print-out:
e.g.:
31.10.07 09:39
Pacific RO
S.No. 9999/07
0.220 MΩxcm
0.005 MΩxcm
31.10.07 10:17
Pacific RO
S.No. 9999/07
Code 0001
31.10.07 16:15
Pacific RO
S.No. 9999/07
Lim.val.permeate
Thermo Scientific Barnstead Pacific RO
Pure water system
33