Ac Cord Bracket - Respironics ESPRIT Service Manual

AC Cord Bracket

REF 580-1000-02 G
Ground lug
with ground
wires
attached
L-bracket
Figure 9-46: Ground Lug and L-Bracket
Follow these steps to remove the AC Cord Bracket (Figure 9-47). (Reverse
removal steps to install.)
CAUTION: Hardware may fall into the Esprit enclosure if the instructions outlined
below are not followed.
NOTE: If the AC Cord Bracket is missing, verify the KEP nuts are not inside the
Esprit enclosure.
1. Remove the top enclosure (see "Top Enclosure" on page 9-4).
2. Remove the AC Distribution Panel (see "AC Distribution Panel" on
page 9-39).
3. Remove the screws, washers, and KEP nuts that hold the AC Cord
Bracket to the AC Distribution Panel (Figure 9-47).
Washers
Screws
Figure 9-47: AC Cord Bracket (Outside and inside views)
Esprit® Ventilator Service Manual © Respironics, Inc.
Component Removal/Installation
L-bracket
KEP nuts
Chapter 9
Ground lug
with ground
wires
removed
9-41