Creatinga Frontfillmix 创建 Frontfillmix; Fx Buses Fx总线 - PRESONUS StudioLive III Series Owner's Manual

5 Buses and Routing
5.5 FX Buses
Pre/ Post Channel Sends 前置/后置通道发送
5.4.2 Creating a Front Fill Mix 创建一个Front Fill Mix
5.5 FX Buses FX总线
You can select the send positions for the channels routed to each Matrix mix. By
default, all Matrix mixes are set to Pre 1. This places the send of every input channel
to each aux bus before the fader, limiter, EQ, and compressor, but after the Polarity
Invert switch, high-pass filter, and gate.
可以为路由到每个Matrix mix混音的通道，选择发送位置。默认情况下，所有
的Matrix mix被设置为Pre 1。将每个input channel 通道的发送放在推子、限制
器、均衡器和压缩器之前，但在 Polarity Invert 切换、高通滤波器和门之后。
From the FlexMix settings menu, you can choose between three send positions for
your mix:
在FlexMix设置菜单中，你的混音可以选择三个发送位置：
Pre 1: Sends each channel to the Matrix bus after the polarity invert, high-pass filter,
and gate. 在polarity invert、高通滤波器和噪声门之后，将每个通道发送到
Matrix 矩阵总线。
Pre 2: Sends each channel to the Matrix bus after all Fat Channel processing (polarity
invert, high-pass filter, gate, compressor, EQ, and limiter) but before the fader. 所有
Fat Channel处理（polarity invert、高通滤波器、噪声门、压缩器、均衡器和限制
器）之后，在推子之前，将每个通道发送到Matrix 矩阵总线。
Post: Sends each channel to the Matrix bus after all Fat Channel processing (polarity
invert, high-pass filter, gate, compressor, EQ, and limiter), and after the fader. 所有
Fat Channel 处理（polarity invert、高通滤波器、噪声门、压缩器、均衡器和限
制器）以及在推子之后，发送每个通道到 Matrix 总线。
Note: Buses on which a GEQ has been inserted will be sent to Matrix mixes before the GEQ.
注意：已插入 GEQ 的总线，在 GEQ 之前会发送到 Matrix mixes 矩阵混音中。
In some venues, the house PA doesn't cover the front rows effectively. This can be
especially problematic in the band on stage is using in-ear monitors instead of floor
wedges. Without floor wedges the people seated in the first few rows are actually
"behind"the PA because they will hear more stage volume from the instruments on
stage than from the front-of-house system. This problem can be solved by placing a
few low profile speakers on the front edge of the stage to cover the first few rows of
the audience.
一 些现 场扩 音器 不 能有 效 地覆 盖 前排 。 舞台 上 的乐 队 使用 入 耳式 监 听 ，
不 是 floor wedges的 情况 下， 可 能会 有 问 题。 如 果没 有floor wedges， 实际
上 坐在 前 几排 的 人是 在 扩音 机 后面 ， 从舞 台 上的 乐 器 中 ，他 们更 多 的会
听 到舞 台 的 音 量， 而 不是 来 自舞 台 前的 系 统。 通过 在 舞台 前 缘放 置 一些
低 矮的 扬 声器 来 解决 这 些问 题 ， 可覆 盖前 几 排的 观 众。
You will want to blend the Main Left/Right mix at a low level with the source signals
that may be difficult to hear, like the vocal and direct bass channels.
你要将 Main Left/Right 混音与可能难以听到的源信号（如人声和直接低音通道）
在低电平下混合，就像人声和直接的低音通道。
FX Buses act just like Aux mixes, but rather than feeding an output, they feed one of
the StudioLive's internal effects processors. This allows you to customize the amount
of a channel's signal that is being effected. Your StudioLive has dedicated FX buses,
each one feeding its own internal FX processor. The StudioLive 64S has 8 internal FX
buses; all other models have 4.
FX Buses 的作用就像 Aux mixes 一样，但它们不是给一个输出，而是给
StudioLive 其中内置的效果处理器。你可以自定义一个受到影响的通道的信号量。
你的 StudioLive 有专门的 FX Buses 总线，每个总线都供给自己的内部 FX 处理器。
StudioLive 64S有8条内部 FX Buses；其他所有型号有4条。
StudioLive™ Series III
Owner's Manual
你
39