PRESONUS StudioLive III Series Owner's Manual page 14

2 Getting Started
2.1 Level Setting Procedure
Ch. 6 Ch. 7 Ch. 8 Ch. 9 Ch. 1 0 Ch. 1 1 Ch. 1 2 Ch. 1 0
6 7 8 9 10 11 12 13
GATE
T hr e s h
-84.00 dB
Gat e
Ch. 8 Ch. 9 Ch. 1 0 Ch. 1 1 Ch. 1 2 Ch. 1 3 Ch. 1 3
8 9 10 11 12 13
13
Select Select Select Select Select Select Select Select
GATE
Th re s h
-84.00 dB
Gate
Press the Input button in the Fat Channel.
7.
按 Fat Channel 的 Input 输入按钮。
7. Turn the first knob in the Fat Channel section (Preamp Gain) counter
- clockwise to its lowest setting.
COM
T hr e s
0.00 d
Com
Fat Channel
将
至最低设置。
8. If your microphone requires phantom power, press the +48v button in the
Fat Channel.
如果你的麦克风需要幻象电源，请按 Fat Channel 的+48v按钮。
Sele
Turn on your powered monitors or power amp. 打开你的有源监听或功放。
10.
Speak or sing into your microphone at the same volume as the performance.
11.
与表演相同的音量，对着麦克风说话或唱歌。
12. Turn the first knob in the Fat Channel section (Preamp Gain) clockwise while
COMP watching the Level (input) meter in the Fat Channel. Adjust the Preamp
Th re s h
0.00 dB
Comp
Gain knob until the meter shows an average level around the middle of its
range. Avoid lighting the red (clip) LED at the top of the meter.
顺时针转动 Fat Channel 部分的第一个旋钮（Preamp Gain），同时观察Fat
Channel 的电平（输入）表。调整Preamp Gain knob前置放大器增益旋钮，
直到电平表显示出其范围中间附近的平均电平。避免亮起仪表顶部的红色
（clip）LED。
部分的第一个旋钮（Preamp Gain），逆时针旋转
StudioLive™ Series III
Owner's Manual
7