Operator's Manual Simple AFG Application
Note: The High Limit doesn't force setting voltages under the limit, but during the
generation the part of the waveform that exceeds the limit will be cut at the High
Limit.
Low Limit [V]
Sets the minimum voltage that the channel generates. This limit is verified during
the generation, but it doesn't take care about the Baseline Offset.
The constraint Low Limit < High Limit must be met.
This feature can be used to ensure the load is not damaged.
Note: The Low Limit doesn't force setting voltages under the limit, but during the
generation the part of the waveform that exceeds the limit will be cut at the Low
Limit.
Output
Sets the output instrument impedance to low (5 Ohm) or to 50 Ohm.
Impedance
[Ohm]
Settings button
Touch the "Settings"
Settings, Trigger Settings and Marker Settings tab.
button to open the dedicated Main Setting Tabs page relative to the, Clock
69