Teledyne T3AWG3K Series Operator's Manual page 53

Hide thumbs Also See for T3AWG3K Series:

Table of Contents

Operator's Manual Simple AFG Application

Waveform

Arbitrary

Amplitude, Offset,

Frequency, Phase

Note: Consult the instrument datasheet to find out the specifications of frequency range for each

waveform.

You can assign the "Arbitrary" waveform using the combo box highlighted in figure below (refer to

"Waveform List" description paragraph):

Note: When Arbitrary waveform is selected, the amplitude and offset of the original waveform are lost

because the waveform in normalized. Anyway, the amplitude and offset of the normalized waveform

can be modified as for any predefined waveforms.

Note: In Stopped State the instrument stops at the Baseline Offset of the selected channel for all the

waveforms except for:

•

Pulse Waveform – Stopped State: Low Level[V] if the polarity is positive or High Level[V] if the

polarity is negative.

•

Double Pulse Waveform – The stopped state is the Offset[V] parameter.

Parameters

AM, FM,

PM, PSK,

PWM

FSK

√

Sweep

Burst

√

Table of Contents

T3awg325x T3awg335x