Slave Multi-Instrument Bar - Teledyne T3AWG3K Series Operator's Manual

Operator's Manual Simple AFG Application

Slave Multi-Instrument Bar

On the Slave device, a new Multi-Instrument bar will appear when it detects the connection with other
T3AWG-3358/3258 units via the Sync cable:
The description of these symbols is summarized in the following table:
It indicates that a slave device has been found
forward on the device chain.
It indicates that the master instrument has not
captured the slave instruments connected. By
sliding the Capture button, the master
instrument will capture and control the
connected devices.
It shows the number of devices that are
controlled by the master instrument after a
Capture event.
It indicates that the master instrument has
captured the slave devices, so it can control the
generation of the whole instruments chain. By
sliding the Release button, the master instrument
will release the control of the connected devices.
It indicates that the instrument is a slave device
and, if captured, it can be controlled by the
master unit.
It indicates that the instrument has not been
captured by the master device.
It indicates that the instrument has been
captured and will be controlled by the master
device.
It indicates that another device has been found
backward on the device chain. It could be the
master unit or another slave unit.
It indicates that another slave device has been
found forward on the chain.
87