Quick Start Wizard Steps - Siemens SITRANS LR460 Operating Instructions Manual

6.2.9

Quick start wizard steps

Notes:
• The Quick Start settings are not independent parameters. The settings are interrelated,
and changes only apply when you click Transfer at the end of step 4.
• Do not use the Quick Start Wizard to modify individual parameters: see instead Parameter
assignment (Page 67). (Perform any customization only after Quick Start has been
completed.)
• Click BACK to return and revise settings, or Cancel to exit the Quick Start.
• Dialog boxes appear as they would using a PROFIBUS PA device. Screens may appear
slightly different when using a HART device.
• The layout of the dialog boxes shown may vary according to the resolution setting for
your computer monitor.
• Each time the Quick Start Wizard is initiated, the start-up settings are factory defaults. The
Wizard will not recall previous user-defined settings.
Open the menu Device – Quick Start, and follow steps 1 to 4.
①
Step 1 - Identification
Click NEXT to accept default values. [Descriptor, Message, and Installation Date (Last config
with HART device) fields can be left blank.]
* Installation Date field appears as Last config with HART device.
SITRANS LR460
Operating Instructions, 10/2021, A5E42035355-AB
Quick start
Commissioning
6.2 Quick start
51