Table of Contents
Advertisement
● Code :
M2-2213
M2-2215
M2-2216
● Symptom / Cause :
Paper transport jam (paper Input section)
1. The paper has not reached the duplex jam 2 senso
1 sensor.
2. When opening the side door, the paper is detected
● Troubleshooting method :
1. Open the side door. Remove the jammed paper.
Close the side door. After warm up, if same jam occ
2. If there is any obstacles on duplex path, remove it.
3. If the feed roller is broken away, reassemble it.
4. Make the duplex 2 jam sensor be pushed by pushin
Close the side door.
Enter the diagnostic mode, and execute the duplex 2
Be the paper at sensor. If "Without paper" message
5. Check if the Side Joint PBA connector is connected
5 Ch
k if th Sid J i t PBA
connector or replace the Side Joint
Service Manual
7. Troubles
shooting
● Error message :
Paper jam at the top
or within a regular time after passing the duplex jam
d at the duplex jam 2 sensor.
curs, check the following.
y
g duplex gate and pulling down the timing belt.
2 jam sensor test.
t
i
t d
PBA(JC92-021
156A).
7-8
81
of duplex path.
is displayed, replace the sensor or the actuator.
properly. If there is any problem, reconnect the
l If th
i
bl
t th
SAMSUNG ELECTRONICS
Advertisement
Table of Contents
