Reassembling the cartridge transfer
1. Install the ITB frame on the Frame Install JIG(A). Ins
top and bottom.
NOTE – Belt Serial No. must be toward the bottom.
Frame Install JIG(A)
NOTE
1. Before assembling the belt, clean the frame roller (D
spray and alcohol.
2. When reassembling the belt, be careful not to be sta
2 Assembling is reverse order of the disassembling
2. Assembling is reverse order of the disassembling.
Note
After assembling the belt, check the inside Rib position
Both Ribs must be located below of the Drive roller, Te
OK Example
NG Example
Service Manual
3. Replacemen
Belt Guide JIG(B)
( )
nt Procedures
unit
stall the Belt Guide JIG(B). And assemble the belt from
(Inside of the Belt)
(Inside of the Belt)
Drv, Tension,Guide A,Guide B,Bk Nip) by using the air
abbed or contaminated.
of the belt.
nsion roller.
3-4
47
Belt Serial No.
SAMSUNG ELECTRONICS