Halogen Lamp - Samsung CLX-9252 Series Service Manual

3.5.3 Halogen Lamp

Perform the following procedure to remove the Haloge
[E]
[F]
[G]
Service Manual
3. Replacemen nt Procedures
en lamp from the Fuser Unit.
1. Remove the Fuser top, NC thermistor holder (refer
to 3.5.1) and Motor (refer to 3.5.3)
2. Take off the support lever belt [E] after removing 2
screws.
3. Take off the frame fuser front [F] after removing 3
screws.
4. Remove the holder harness [G] rear after
removing 2 screws.
5. After 4 step, release the harness from the
holder harness.
CAUTION
Be careful not to damage in harness.
The damage of the harness can make a fire
caused by a short circuit.
3-2 29
SAMSUNG ELECTRONICS