Table of Contents
Advertisement
● Code :
M2-1331
M2-1333
M2-1334
● Symptom / Cause : Paper transport jam (paper Inp
- The paper has not reached the fuser out sensor with
- The fuser out sensor is not off within normal time afte
● Troubleshooting method :
1. Open the side door. Remove the jammed paper.
p
Close the side door. After warm up, if same jam occ
2. If there is any obstacles between the tray1 feed rolle
nd
3. If the 2
transfer roller or assembly is damaged, rep
4. If the problem persists, separate the side unit from s
4 If th
bl
5. If Cam, lever, spring of the 2
(JC95-01038A)
6. If the actuator-fuser out, guide-face up exit are dama
7. Enter the diagnostic mode, and execute the fuser ou
Fix the actuator and be the paper at sensor. If "Witho
sensor.
8. Check if the fuser out sensor connector is connected
9. Replace the Joint PBA(JC92-02156A) of the side un
9 R
l
th J i t
10. Replace the harness of the side unit.
11. Check if the connector of the main board is connec
12. Replace the main
p
Service Manual
● Error message :
Paper jam inside of m
j
i t
t th
id
nd
transfer roller engage
PBA(JC92
02156A) f th
board(JC92-02580A(for 9352) /
(
7. Troubles
shooting
machine.
put section)
hin normal time after passing the regi sensor.
er the fuser out sensor on.
p p
curs, check the following.
er and the regi roller, remove it.
place it.
it f
set. And check the following.
t A d h
e device are damaged, replace the 2
aged, replace them.
ut sensor test.
out paper" message is displayed, replace the
d properly. Reconnect the connector.
id
nit.
it
cted properly. Reconnect the connector.
(
)
JC92-02581A(for
7-7
79
k th f ll
i
(
9252))
))
SAMSUNG ELECTRONICS
nd
transfer roller.
Advertisement
Table of Contents
