Table of Contents
Advertisement
● Code :
C6-1311
● Symptom / Cause :
The fuser unit is not installed properly.
The connector of fuser unit is not connected properly.
● Troubleshooting method :
1. Turn the machine off.
2. Open the side cover and check if the fuser unit is in
2. Open the side cover and check if the fuser unit is in
3. If the fuser unit is installed, check the following :
a. Check if the both handle lockers are locked prope
b. Check the draw connector between the fuser unit
c. Check if the draw connector is disconnected.
4. Remove the fuser unit and re-install it.
a. Open the side cover.
b. Remove 2 screws.
c. Take off the fuser unit while holding both handles
d. Install the fuser unit.
CAUTION
The temperature gets high in the vicinity of the fuser u
replacing it, make sure that fuser unit has cooled.
5. Turn the machine on.
6. If the problem persists, replace the fuser
Service Manual
7. Troubles
● Error message :
Fuser unit is not inst
[A]
unit(JC91-
shooting
:
talled correctly. Install it.
stalled properly.
stalled properly.
erly.
t and the machine.
s.
unit. When replacing it, you may get burned. Before
-01142A(220V)/
JC91-01141A(110V)).
7-6
61
SAMSUNG ELECTRONICS
Advertisement
Table of Contents
