Acquisition Mode - JAI GO-5000M-PGE-UV User Manual

GO-5000M-PGE-UV User Manual (Ver. 1.2)

Acquisition Mode

On this camera, the following three acquisition modes are available.
Single Frame
In single frame mode, executing the AcquisitionStart command causes one frame to be captured. After
one frame is captured, this operation is automatically stopped.
In order to restart the capture, it is necessary to input the AcquisitionStart command again. BlockID is
not reset until AcquisitionStop is input and is incremented when the AcquisitionStart command is
called.
◆ Normal single frame operation
1. AcquisitionStart command is input
2. AcquisitionActive becomes "TRUE" (accepts capture)
3. 1 frame is output
4. AcquisitionActive becomes "FALSE" (stop capturing)
5. Output is stopped
Note: This figure is if the trigger mode is OFF. When the trigger mode is ON, FrameActive
becomes True at different AcquisitionActive timing.
◆ Forcing acquisition to stop
While AcquisitionActive is "TRUE", if AcquisitionStop or AcquisitionAbort is initiated, AcquisitionActive
becomes "FALSE" (stop capturing).
However, if AcquisitionStop command is initiated during image output period, AcquisitionActive
becomes "FALSE" (stop capturing) after image output is completed.
- 51 -
Main Functions