Acquisition Control - JAI GO-5000M-USB-UV User Manual

Acquisition control

Acquisition control contains the following commands.
Acquisition Mode
In the GO-5000M-USB-UV, the following three acquisition modes are available.
Single Frame
In single frame mode, executing the AcquisitionStart command causes one frame to be captured.
After one frame is captured, this operation is automatically stopped.
In order to restart the capture, it is necessary to input the AcquisitionStart command again.
BlockID is not reset until AcquisitionStop is input and is incremented when the AcquisitionStart
command is called.
◆ Normal single frame operation
1) AcquisitionStart command is input
2) AcquisitionActive becomes "TRUE" (accepts capture)
3) 1 frame is output
4) AcquisitionActive becomes "FALSE" (stop capturing)
5) Output is stopped
Note: This figure is if the trigger mode is OFF. When the trigger mode is ON, FrameActive
becomes True at different AcquisitionActive timing.
Single Frame operation.
◆ Forcing acquisition to stop
While AcquisitionActive is "TRUE", if AcquisitionStop or AcquisitionAbort is initiated,
AcquisitionActive becomes "FALSE" (stop capturing).
However, if AcqusitionStop command is initiated during image output period,
AcqusitionActive becomes "FALSE" (stop capturing) after image output is completed.
— 33 —
GO-5000M-USB-UV