JAI GO-5000M-PGE-UV User Manual page 30

GO-5000M-PGE-UV User Manual (Ver. 1.2)
Line Source Item
Line 5 Opt In
NAND 0 Out
NAND 1 Out
Line Mode
Indicates the status of the item selected in Line Selector. (Input, Output or Internal)
Line Inverter
Sets the polarity of the selected input or output. (False or True)
Line Status
Indicates the status of the selected signal (input or output) (True=High, False=Low)
Line Format
Indicates the format of the line item selected in Line Selector (No Connect, TTL, LVDS, Opt Coupled or
Internal Signal).
Note: On this camera, TTL and LVDS interface are not equipped.
Action Control
Action control settings allow the use of unicast or broadcast Action Commands as defined in the GigE
Vision 2.0 specification. ACTION_CMD messages received via the GVCP port can control the
camera's internal action signals provided the camera's action control settings match the settings of the
message received. This function is useful for triggering an action in multiple cameras at roughly the
same time. There are two action control inputs on the GO-5000M-PGE-UV and they are connected to
four triggers, counter reset, counter, and timer.
When action control is used, the trigger input source should be set to Action 1 or Action 2 in advance.
ActionDeviceKey
Sets the device key value for the camera in a 32-bit register. This value must match the device_key
value of the ACTION_CMD message in order for the message to be acted upon.
ActionSelector
Selects Action 1 or Action 2 for setting the action control values.
Connect Opt In signal to line 6 in Line Selector
Connect NAND 0 signal to line item selected in Line Selector
Connect NAND 1 signal to line item selected in Line Selector
Description
- 30 -
Main Functions