Commissioning, Ip Address - MICRO-EPSILON capaNCDT 6200 Quick Manual

Commissioning, IP Address

Commissioning, IP Address
The controller is shipped with the factory-set
IP address 169.254.168.150.
You can query the IP addresses of the
controllers that are connected to a PC or
network by using the sensorTOOL program.
This program is available online at
www.micro-epsilon.com/download/software/
sensorTOOL.exe.
Start the sensorTOOL program and
click the button.
Select the correct controller from the list.
Click the Open Website button to con-
nect the sensor to your default browser.
OR: If DHCP is active and the DHCP server is
linked to the DNS server, access is also pos-
sible by using e.g., DT6200_SN01234567
(where "01234567" is the serial number of
your controller).
Start a web browser on your PC. Enter
DT6200_Serial_number in the ad-
dress bar of your browser.
capaNCDT 6220/6222/6230
The controller supports UPnP . If you have an operating system
where the UPnP service is enabled, e.g. by default in Windows 7,
the controller is automatically listed in Explorer under network devic-
es and can be accessed from there, e.g. if you have forgotten its IP
address.
https://
First interactive web page after calling the IP address
Additional help functions (e.g. Settings) are available in the top
navigation bar. All settings on the web page are implemented in the
controller immediately.
Parallel operation with web browser and Telnet commands is possi-
ble; the last setting applies.
The appearance of the web pages can change depending on the
functions and the peripherals. Each page contains parameter de-
scriptions and thus tips for configuring the controller.
2279
Page 16