MICRO-EPSILON capaNCDT 6200 Quick Manual page 15
Hide thumbs
Also See for capaNCDT 6200:
- Operating instructions manual (112 pages) ,
- Operating instructions manual (116 pages) ,
- Operating instructions manual (92 pages)
Table of Contents
Advertisement
Commissioning
Ethernet/EtherCAT Switching DT6230
Switch for changing between Ethernet and EtherCAT
You can change between Ethernet and EtherCAT by
using the hardware switch on the DT6230 base module
or in the software.
If the switch is in the EN (
) position, the Ethernet
Ethernet
interface is always active irrespective of the software
setting. If the switch is in the EN/EC
(Ethernet/EtherCAT)
position, the interface set by the software is active. Any
change to the interface only takes effect after restarting
the controller.
capaNCDT 6220/6222/6230
Page 15
Advertisement
Table of Contents
Need help?
Do you have a question about the capaNCDT 6200 and is the answer not in the manual?
Questions and answers