Preparing For Mma Welding - Weco Multi Power 204T Instruction Manual

Cod. 006.0001.1420
08/09/2021 V.2.12
ENGLISH

2.4 PREPARING FOR MMA WELDING

1. Set the welding power source ON/OFF switch to "O" (unit off).
2. Plug the power cable plug into a mains socket.
3. Choose the electrode based on the type of material and thickness of the workpiece to be welded.
4. Insert the electrode in the electrode holder.
5. Connect the electrode holder clamp plug to the following welding socket: Positive pole welding
socket.
6. Connect the earth clamp plug to the following welding socket: Negative pole welding socket.
7. Connect the earth clamp to the workpiece being processed.
Read the warnings highlighted by the following symbols in the "General prescriptions for use".
8. Set the welding power source ON/OFF switch to "I" (unit on).
9. Select the following welding mode on the user interface: MMA
10. Set the required welding parameter values on the user interface.
When the remote control [RC] is connected and enabled, the welding current can be adjusted.
The system is ready to start welding.
REAR VIEW
8
WELD THE WORLD
DANGER!
Electric shock hazard!
RC
REMOTE
CONTROL
Multi Power 204T
FRONT VIEW