Table of Contents
Advertisement
Multi Power 204T
1. Position the torch
2. Press the torch
with the electrode on
trigger and keep it
the workpiece.
pressed.
PROCEDURE WITH CONTINUOUS PRESSURE OF TORCH TRIGGER
○ Bring the torch up to the work until the electrode tip is approximately 2 or 3 mm away.
○ Press (1T) torch trigger.
○ The arc strikes without contact with the workpiece and the voltage discharges (HF) cease auto-
matically.
○ The welding current reaches the preset value, by way of a up slope time, if programmed.
○ The welding procedure continues, at the preset current, for the time set with the spot time param-
eter.
○ The current reaches the end current value in the time set in the down slope time parameter.
○ The arc is extinguished.
○ Gas delivery continues for the time set in the post gas parameter.
○ Touch the workpiece with the torch electrode.
○ Slowly lift the torch to strike the arc.
The welding parameters are available in accordance with the selected welding mode and procedure.
Certain parameters are available only after other parameters or functions of the unit have been enabled
or set.
The table shows the settings required to enable each parameter.
LEGEND
√: Always available
1: Available with the user interface reference active
2: Available with rC= on and remote controller connected
3: Available with HF= on
4: Not available with M.ta. active
5: Available with PUL.= Slo.
WELD THE WORLD
3.
Lift
the
torch
4. The arc ignites for
slightly.
a few hundredths of
As
soon
as
the
a second (time can
electrode
is
lifted
be set up).
then the HF ignition
starts.
Cod. 006.0001.1420
08/09/2021 V.2.12
ENGLISH
5. The result of this
is a very precise,
not oxidized weld-
ing spot without any
plastic deformation
of the sheet.
47
Advertisement
Table of Contents
