Table of Contents
Advertisement
Multi Power 204T
L13
L14
L15
L16
L17
L18
L19
L20
L21
L22
L21 + L22
L23
L24
L25
L26
L27
L28
L29
L30
L31
L32
L33
WELD THE WORLD
Illumination shows that the following parameter can be set: Q-START
Illumination shows that the following parameter can be set: DYNAMIC ARC
Illumination shows that the following parameter can be displayed: MULTI TACK
Illumination shows that the following parameter can be set: STARTING CURRENT (%/A)
Illumination shows that the following parameter can be set: SLOPE UP (s)
Illumination shows that the following parameter can be set: WELDING CURRENT (A)
Illumination shows that the following parameter can be set: SECOND CURRENT B-LEVEL (%)
Illumination shows that the following parameter can be set: BASE CURRENT (A)
Illumination shows that the following parameter can be set: PEAK TIME (s)
illumination shows that the following parameter can be set: BASE TIME(s)
illumination shows that the following parameter can be set: PULSED CURRENT FREQUENCY
(Hz/kHz)
illumination shows that the following parameter can be set: SLOPE DOWN (s)
illumination shows that the following parameter can be set: STARTING CURRENT (%/A)
illumination shows that the following parameter can be set: POST-GAS (s)
Illumination shows that the following function has been activated: 2 stroke procedure.
Illumination shows that the following function has been activated: 4 stroke procedure.
Illumination shows that the following function has been activated: 4 stroke Bi-level procedure
Illumination shows that the following function has been activated: 2 stroke spot procedure
(SPOT).
This LED illuminates to show that the following welding mode is selected: MMA
This LED illuminates to show that the following welding mode is selected: TIG DC CONTINU-
OUS
This LED illuminates to show that the following welding mode is selected: PULSED DC TIG
This LED illuminates to show that the following welding mode is selected: SYNERGIC PULSED
TIG
When this is on, it means that the synergic mode is active and that the operator can set just the
welding current while the other parameters are automatically regulated by the machine. The
synergy is optimised by angle welding.
Cod. 006.0001.1420
08/09/2021 V.2.12
ENGLISH
11
Advertisement
Table of Contents
