Installation; Connections To The Mains Power Supply; Front Panel - Weco Multi Power 204T Instruction Manual

Cod. 006.0001.1420
08/09/2021 V.2.12
ENGLISH
Accessories that can be connected to the unit:
• manual remote control for remote adjustment of the welding current.
• foot-pedal remote control for TIG torch arc striking and remote adjustment of welding current.
• UP/DOWN torch or torch with potentiometer.
• liquid cooler for TIG torches.
2

INSTALLATION

Read the warnings highlighted by the following symbols in the "General prescriptions for use".

2.1 CONNECTIONS TO THE MAINS POWER SUPPLY

The characteristics of the mains power supply to which the equipment shall be connected are given in
the chapter entitled "12 TECHNICAL DATA" on page 48.
The machine can be connected to motor-generators provided their voltage is stabilised.
Connect/disconnect the various devices with the machine switched off.

2.2 FRONT PANEL

○ Negative pole welding socket.[Item 1].
○ Positive pole welding socket.[Item 2].
○ Connector for logic signals of TIG torch.[Item 3].
○ Connector for gas feed hose: Torch power source [Item 4].
6
WELD THE WORLD
DANGER!
Lifting and positioning
2 3 4
Multi Power 204T
1