Weco Multi Power 204T Instruction Manual page 37

Multi Power 204T
Tab. 14 - Recommended MULTITACK parameters
Sheet thickness (mm)
0.6 mm
0.8 mm
1.0 mm
1.5 mm
2.0 mm
2.5 mm
3.0 mm
○ It is recommended that a pre-gas time of between 0.3 - 0.5 seconds be used in order to have op-
timum protection right from the ignition, thus avoiding the oxidation of the initial part of the weld.
This is also the same for the final part where it is recommended that a post gas time not less than
3 seconds is used.
WELD THE WORLD
CORNER/BUTT JOINT
Current (A)
40 A - 60 A
60 A - 80 A
80 A - 100 A
90 A - 110 A
110 A - 130 A
130 A - 150 A
150 A - 160 A
160 A - 170 A
170 A - 180 A
180 A - 200 A
Cod. 006.0001.1420
08/09/2021 V.2.12
ENGLISH
Multitack FREQUENCY (Hz)
1.0 - 1.5
1.0 - 1.5
1.0 - 1.5
1.0 - 1.5
1.0 - 1.5
1.5 - 2.0
1.0 - 1.5
1.5 - 2.0
1.0 - 1.5
1.5 - 2.0
37