Loading A Job; Selecting Jobs Using The Torch Buttons - Weco Multi Power 204T Instruction Manual

Multi Power 204T

12.3 LOADING A JOB

L5
L4
L7
L6
L8
L9
L13
L14
L15
○ Press and release the S4
L.xx : Only after loading the job, the message will appear on display D1.
A
• xx= number of the last job used.
nO.J : If there are no saved jobs, the message will appear on display D1.
B
○ Using the encoder E1
○ Press theS4
C
The LED will illuminate.
To quit the currently loaded JOB, change any setting on the power source user interface. Press any
(except S4) to exit without confirming.
button

12.4 SELECTING JOBS USING THE TORCH BUTTONS

When an UP/DOWN torch is installed you can select the JOBs by using the buttons on the welding
torch.
Select and upload one of the JOBs (e.g. J.06) on the power source user interface.
Use the buttons on the welding torch to scroll the JOBs saved.
WELD THE WORLD
D1 L1 L2 L3 L12
L.
L18 L19 L21
L17
L16
L20
S2 S3
ACTIVATION
CONFIRMATION
button to activate the LOAD JOB menu.
, select the job number to be loaded.
button to load the JOB and exit from the menu.
L10 L11 S1 E1
L25
L23
L22
L24
L26 L27 L29 L28
S4 S5
A
C
Cod. 006.0001.1420
08/09/2021 V.2.12
ENGLISH
B
SELECTION
L30
L31
L32
L33
SYN
S6
51