Installation And Configuration; Rack Mounting - Advantech FWA-2320 User Manual

1u entry-level network appliance based on intel atom c2000 system on chip
Table of Contents

Advertisement

1.3

Installation and Configuration

The FWA-2320 comes as a pre-configured system with CPUs, memory and peripher-
als installed in the unit. In the rare case that you procured a barebone system or need
to install components in the FWA-2320 for any other reason, please refer to section
3.
1.3.1

Rack Mounting

The FWA-2320 appliance is designed to be installed in a standard 19-inch rack.
Please follow the basic guidelines below for rack mounting:
1.
Mount the mounting ears on the each side of the unit using the screws included.
1).
Locate the threaded mount holes on the chassis on the side, close to the
front panel.
2).
Place the mounting ear over the holes and insert the three screws. Do not
tighten the screws immediately.
Figure 1.2 Mounting ear screws inserted but not fastened yet
3).
After all screws have been inserted, hand tighten them using a PH2 screw
driver to ensure secure installation.
2.
Ensure the rack is adequate for the unit (weight) and the application.
3.
Use the mounting hardware recommended by the rack manufacturer to mount
the unit in the rack. Four mounting screws, compatible with the rack design,
must be used and hand tightened to ensure secure installation
4.
While Advantech does not supply support brackets, slide rails are available for
separate order. Please refer to section 2.5 for options.
5.
Choose a mounting location where all four mounting holes line up with those of
the mounting bars of the 19-inch cabinet.
6.
Choose a mounting location that does not block any air inlet and air outlet areas
of the unit, It is also recommended to factor in heat generated by adjacent
equipment and to avoid exposure to direct sunlight when mounting the unit. If
installed in a closed or multi-unit rack assembly, the operating ambient tempera-
ture of the rack environment may be greater than room ambient. Therefore, con-
sideration should be given to installing the equipment in an environment
compatible with the maximum recommended ambient temperature per section
2.3.
Figure 1.1 Mounting ear thread holes
5
FWA-2320 User Manual

Advertisement

Table of Contents
loading

Table of Contents