Advantech FWA-2320 User Manual page 82

3.4.2 LAN Bypass
LAN Bypass Firmware can be upgraded via the LAN Bypass Software. Please refer
to the Advanced LAN Bypass User's Manual for details.
3.5 Replacing FRUs
Please make sure you follow the safety guidelines presented in section1.1 when
making changes to the hardware.
For instruction on how to remove and install the top cover of the unit please refer to
section 3.3.
3.5.1 Disk Drives
3.5.1.1 2.5" HDD
You need:

a PH2 screw driver
A standard 2.5" SATA HDDTo remove the HDD, proceed in the reverse of the installa-
tion procedure in section 3.3.1.1:
1. Detach the HDD power and SATA cables
2. Remove the four screws on the corners of the HDD carrier plate and remove the
HDD carrier plate from the system
3. Remove the HDD mounting screws and extract the HDD from the carrier plate.
4. Install a new HDD by following the instructions in section 3.3.1.1.
3.5.1.2 USB DOM
You need:

a PH2 screw driver

a standard USB DOM
To remove a USB DOM proceed in the reverse of the installation procedure in section
3.3.1.2:
1. Remove the USB DOM mounting screw..
2. Extract the USB DOM by pulling the DOM upwards evenly. Be sure not to bend
any USB DOM connector pins.
3. Install a new SSD following the mounting instructions of the same section.
FWA-2320 User Manual 72