Table of Contents
Advertisement
An USB DOM compliant module can be installed at location M6:
Figure 3.34 USB DOM site with header & standoff
1.
Make sure the USB DOM is compliant with the socket.
2.
Insert the DOM onto the header from the top. Make sure the header and recep-
tacle align properly as shown below
3.
If properly inserted. The mount hole in the DOM and the threaded insert will be
aligned. Insert the DOM mounting screw and tighten it.
Figure 3.35 USB DOM alignment
Figure 3.36 USB DOM mounting
67
FWA-2320 User Manual
Advertisement
Table of Contents
