Advantech Oem Command 'Store Configuration Settings - Advantech FWA-6171 User Manual

2u rackmount network appliance

Hide thumbs

Table Of Contents

Table of Contents

BIOS Data Exchange

Set Guard Time

BIOS Rollback Options

Trigger Payload OS Interrupt

Get BIOS Boot Bank ID

Set BIOS Boot Bank ID

Reset Hardware Device

Write EEPROM Test Byte

Read EEPROM Test Byte

Reload BMC Default Configuration

Get Core Version

Reload Factory Defaults

This command is used to store configuration settings, and it is used to enable or disable the NC-SI

"Keep PHY Link Up" setting of the management LAN port.

If the "Keep PHY Link Up" setting is enabled, the BMC will keep the PHY link up regardless of x86

host/OS link state. This is required for SoL applications where the connection needs to stay alive

across reboots, i.e. when using SoL to access the BIOS menu and/or related reboots.

However if a user needs to manually change the configuration of x86 management port, such as

using the 'ethtool –s ethx autoneg off' command to turn off auto-negotiation, the NC-SI "Keep PHY

Link Up" setting MUST be disabled first to allow the changes to take effect.

Be sure to re-enable the "Keep PHY Link Up" setting once finishing LAN port configuration changes

on OS level.

_20220127_JH.DOCX

User Manual_FWA-6171

4.1.2