3.
Insert the screws supplied as part of the HDD kit into the holes and HDD
threads. Make a few turns on each screw only using a PH2 screw driver until the
threads start to engage. Then move on to the next screw. When all four screws
have been inserted, fasten the screws tightly.
4.
Move the carrier plate into the system location M7 and align the carrier plate's
mounting holes with the standoffs in the chassis.
FWA-2320 User Manual
Figure 3.27 Screw insertion and fastening
Figure 3.28 HDD Carrier plate screw locations
64