3.3
Installing Components
Please make sure you follow the safety guidelines presented in section 1.1 when
making changes to the hardware.
3.3.1
Removing the Top Cover
You need:
a PH2 screw driver
The top cover is secured by a total of 6 screws, 2 each on the left, rear and right side:
Figure 3.21 Top cover screw locations ( left/rear/right)
To remove the top cover, remove these screws using a PH1 screw driver. Be sure to
keep the screws in a safe place for top cover re-installation.
After that, slide the top cover backwards until the front flange of the top cover disen-
gages with the unit's face plate:
Figure 3.22 SlideTop Cover back
61
FWA-2320 User Manual