Table of Contents
Advertisement
1.5.1.4
VCC current consumption in LTE connected mode
During an LTE connection, the module can transmit and receive continuously due to the Frequency Division Duplex
(FDD) mode of operation used in LTE radio access technology.
The current consumption depends on output RF power, which is always regulated by the network (the current
base station) sending power control commands to the module. These power control commands are logically
divided into a slot of 0.5 ms (time length of one Resource Block), thus the rate of power change can reach a
maximum rate of 2 kHz.
The current consumption profile is similar to that in 3G radio access technology. Unlike the 2G connection mode,
which uses the TDMA mode of operation, there are no high current peaks since transmission and reception are
continuously enabled in FDD.
In the worst case scenario, corresponding to a continuous transmission and reception at maximum output power
(approximately 250 mW or 24 dBm), the average current drawn by the module at the VCC pins is considerable
(see the "Current consumption" section in LARA-R2 series Data Sheet [1]). At the lowest output RF power
(approximately 0.1 µW or –40 dBm), the current drawn by the internal power amplifier is strongly reduced and
the total current drawn by the module at the VCC pins is due to baseband processing and transceiver activity.
Figure 8 shows an example of the module current consumption profile versus time in LTE connected mode.
Detailed current consumption values can be found in LARA-R2 series Data Sheet [1].
Current [mA]
700
600
500
400
300
200
100
0
Figure 8: VCC current consumption profile versus time during LTE connection (TX and RX continuously enabled)
UBX-16010573 - R12
Current consumption value
depends on TX power and
actual antenna load
1 Slot
1 Resource Block
(0.5 ms)
LARA-R2 series - System Integration Manual
1 LTE Radio Frame
(10 ms)
Time
[ms]
System description
Page 24 of 157
Advertisement
Table of Contents
