Table of Contents
Advertisement
6-2
The Example Application Program
Installing the Software
Creating the Example
Application
Publication 1756-6.5.19 - May 2000
To install the RSLogix 5000 software:
1. Insert the CD in the CD-ROM drive.
Note: The CD-ROM supports Windows Autorun. Once inserted into
the CD-ROM drive, if you have Autorun configured, the installation
will automatically start at the first setup screen.
If Autorun is not configured for your CD-ROM drive, go to step 2.
2. From the Start menu, choose Run.
You will see the Run pop-up window.
3. Type d:/setup (if it doesn't appear automatically), where d: is your
CD-ROM driver letter.
4. Click on OK.
You will see the progress bar, followed by the welcome screen.
The following sections describe how to create the example
application using the RSLogix 5000 software.
Creating a New Controller
The first step is to create a new controller. Use the following
procedure.
1. Start RSLogix 5000. You will see the window shown below.
Advertisement
Table of Contents
