Table of Contents
Advertisement
What This Chapter Contains
1
Configuring DeviceNet From
Another Network
This chapter describes how to configure a DeviceNet network
remotely from another network. It provides examples of configuring
the DeviceNet network from ControlNet, Ethernet, and Data Highway
Plus networks.
We assume that you have previously set up the network you will use
to communicate with the DeviceNet network and that you have
installed the appropriate interface hardware. For these examples we
set up a 7-slot ControlLogix chassis with the following modules:
Slot 0
1756-L1, Logix5550 controller
Slot 1
1756-DNB, DeviceNet Interface module
Slot 2
1756-DHRIO, Data Highway Plus Interface module
Slot 3
1756-CNB, ControlNet Interface module
Slot 4
1756-ENET, Ethernet Interface module
The following table describes what this chapter contains and where to
find specific information. Refer to the section(s) that apply to your
installation.
For information about
Where to Find More Information
Configuring DeviceNet from a ControlNet Network
Configuring DeviceNet from an Ethernet Network
Configuring DeviceNet From a Data Highway Plus Network
5
Chapter
See page
5-2
5-2
5-5
5-8
Publication 1756-6.5.19 - May 2000
Advertisement
Table of Contents
