Oim Parameters Cross-Referenced To Software I/M Parameters And - Rockwell Automation Reliance Electric GV3000/SE User Manual

OIM Parameters Cross-Referenced to
Software I/M Parameters and
Parameter Numbers
The parameter names used on the OIM and the nameslisted in the software I/M are
slightly different. Table A.1 lists all of the OIM parameter namesand the corresponding
software I/M parameter name. It also lists the menu path used to access the parameter
through the OIM. You can accessall of the parameters through the All Parameters menu.
Table A.2 lists parameters by parameter number.
The RMI parameters listed here are described in the Remote Meter Interface (RMI)
Board I/M (D2-3341).
Table A.1 — OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers
Software I/M Parameter
OIM Parameter Name Parameter Name Type Number OIM Menu Path
AC LINE VOLTAGE AC Line Volts Input H.021 Application Setup
(V/Hz)
AC LINE VOLTAGE AC Line Volts Input U.018 Application Setup
(Vector)
ACCEL TIME Accel Time 1 (RAMP 1) Input P.001 Speed Control = Accel
& Decel Times
Quick Start (V/Hz and
Vector)
ACCEL TIME - Accel Time 2 (RAMP 2) Input P.017 Speed Control = Accel
SECONDARY & Decel Times
AUTO/MAN KEY AUTO/MANKeyDisable Input P.052 Application Setup (V/Hz
DISABLE* and Vector)
AVOID FREQ BAND 1 Avoidance Frequency Input H.011 Application Setup
Band 1 (V/Hz) >
Avoidance Frequencies
AVOID FREQ BAND 2 Avoidance Frequency Input H.013 Application Setup
Band 2
(V/Hz) =>
Avoidance Frequencies
AVOID FREQ BAND 3 Avoidance Frequency Input H.015 Application Setup
Band 3
(V/Hz) = Avoidance
Frequencies
OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers
A-1