Table of Contents
Advertisement
RSLogix 5000
Configuration Software
1
Configuring the SynchLink Module
This chapter describes how to configure the ControlLogix SynchLink module
using RSLogix 5000.
Table 5.1
For information on:
Overview of the Configuration Process
Choose a SynchLink Configuration
Creating a New Module
Downloading New Configuration Data
Changing Configuration After Module Operation Has Begun
You must configure your module upon installation. The module will not work
until it has been configured.
This chapter offers a configuration overview and the three available
ControlLogix SynchLink configurations. For specific examples of each
configuration, see the following:
• Star Configuration - Appendix B - This example shows a configuration
using Remote Axis Data.
• Daisy Chain Configuration - Appendix C
• Ring Configuration - Appendix D
Use RSLogix 5000 to write configuration for your SynchLink module. You
must write configuration for each module because module position in the
SynchLink system affects configuration. For example, if a SynchLink module is
the Time Master for the system, it must be configured as such.
Chapter
See page:
5-2
5-3
5-4
5-8
5-9
Publication 1756-UM521C-EN-P - July 2004
5
Advertisement
Table of Contents
